MIMAKI JFX200-2531 - Page 88

3-34
Setting Work Change
10
Press to select a set value.
11
Press the key.
12
Press the key several times to end the setting.
• This setting is enabled only while the toggle print function is enabled.
• For the setting procedure, refer to "Setting automatic area toggling for toggle printing" in
P.3-7 "Toggle printing".
• When the toggle print function is disabled, there is no need to change the setting.
SETUP
WO R K C H A N G E [ E N T ]
SETUP
WO R K C H A N G E [ E N T ]
SETUP
WO R K C H A N G E [ E N T ]