MIMAKI JFX200-2531 - Enabling the Toggle Print Function

3-8
Enabling the toggle print function
To enable the toggle print function, set the toggle print from the FUNCTION menu.
When the toggle print function is set to OFF, toggle printing is disabled.
When the toggle print function is set to ON, toggle printing is enabled.
1
Press the key in LOCAL.
2
Press to select [TOGGLE PRINT].
3
Press the key.
4
Press the key.
5
Press to select a set value.
• OFF: Disables the toggle print function.
• ON: Divides the area into two areas and enables the toggle print function.
6
Press the key.
• When the settings are not changed, proceed to step 9.
• When any set value is changed, proceed to step 8.
7
Press to select whether to clear the origin
setup.
NO: The printing origin and thickness of the media are set as shown in the table below.
YES: The printing origin and thickness of the media are set as shown in the table below.
Division setting Printing origin Media thickness
OFF The value set for the FRONT side is set.
ON
Both for the FRONT side and REAR side, the current values
are set.
Division setting Printing origin Media thickness
OFF Cleared.
The value set for the FRONT
side is set.
ON
The values set both for the
FRONT side and REAR side
are cleared.
Both for the FRONT side and
REAR side, the current
values are set.
FUNCT I ON
VIEW [ENT]
FUNCT I ON
TOGGLE PR I NT [ ENT ]
TOGGLE PR I NT
TOGGLE PR I NT [ ENT ]
TOGGLE PR I NT
OFF [ ENT ]
TOGGLE PR I NT
ON [ ENT ]
TOGGLE PR I NT
ON [ ENT ]
CLEAR OR I G I N SETUP
NO < > YES