MIMAKI JFX200-2531 - Page 73

Toggle Printing
3-19
1
1
3
Convinient use
5
6
Changing printing origin with FUNCTION menu
1
Press the key in LOCAL.
2
Press to select [SET ORIGIN].
3
Press the key.
4
Press to select the area to set the origin.
5
Press the key.
6
Press to select [X OFFSET] or [Y OFFSET].
X OFFSET: Setting the origin position of X-axis.
Y OFFSET: Setting the origin position of Y-axis.
7
Press the key.
8
Press to input a value.
9
Press the key.
• For the setting procedure when the toggle print function is set to OFF, refer to P.3-2 "Changing origin".
• When [[F]/[R] SETUP] is set to "COMMON", the same setting procedure is used as with the case
where the toggle print function is set to OFF. For details about the setting procedure, refer to P.3-2
"Changing origin". The set value is registered to both FRONT/REAR areas.
FUNCT I ON
VIEW [ENT]
FUNCT I ON
SET OR I G I N [ ENT ]
AREA
:FRONT
AREA
:REAR
[R]ORIGIN 0mm
SELECT : X OFFSET
[R]ORIGIN 0mm
SELECT : Y OFFSET
[R]ORIGIN 2500mm
YOFFS: 0mm
[R]ORIGIN 2000mm
YOFFS: 500mm
[R]ORIGIN 500mm
SELECT : Y OFFSET