MIMAKI JFX200-2531 - Page 85

3-31
1
1
3
Convenient use
5
6
Perform setting to reduce stripes between passes
4
Press the key.
5
Press to select “MAPS2” and press the
key.
•Set Value：MAPS1, MAPS2, OFF
• If you selected OFF, proceed to step 11.
6
Press to select “AUTO” or “MANUAL”.
• AUTO : Set the print pattern and smoothing level to the
recommended value automatically depending on
printing mode.
• MANUAL : You can adjust the set value.
7
Press the key.
• When selecting the “AUTO” in the Step 6, proceed to the step 11.
• When selecting the “MANUAL” in the Step 6, proceed to the step8.
8
Make the settings for the inks.
(1) Press to set the COLOR.
• AUTO : A pattern that matches the print mode will
be set automatically.
• Pattern 1 to 5 : The pattern that you select will be printed.
(2) Press the key.
• A screen for setting SMOOTHING.LV will appear.
(3) Press to set the SMOOTHING LV..
• AUTO : A pattern that matches the smoothing level will
be set automatically.
• 5 to 100% :
The MAPS2 effect become strong as the set value
increase, and become weak as the set value
decrease.
(4) Press the key, and then press key.
• A screen for setting SPOT will appear.
(5) Press to set the SPOT.
• AUTO : A pattern that matches the print mode will
be set automatically.
• Pattern 1 to 5 : The pattern that you select will be printed.
• If feeding stripes and color change is not improved by “AUTO” setting, please adjust the
print pattern and smoothing level by “MANUAL” setting.
MAPS
:OFF
MAPS 2
:AUTO
MAPS 2
:MANUAL
COLOR >
PATTERN : 1
COLOR >
PATTERN : AUTO
COLOR >
SMOOTH I NG LV . : AUTO
COLOR >
SMOOTH I NG LV . : 5 0%
<SPOT >
PATTERN : AUTO
<SPOT >
PATTERN : AUTO