MIMAKI JFX200-2531 - Page 123

When Nozzle Clogging Cannot Be Solved
4-21
1
1
1
4
Routine Maintenance
4
Press to select the Nozzle line that needs
NOZZLE RECOVERY and press the key.
5
Register the Nozzle number that needs NOZZLE
RECOVERY and press the key.
(1)
Select the registration number from 1 to 10 by pressing
and press the key.
(2) Register the nozzle number that needs recovery by pressing
and press the key.
6
Press the key several times to end the setting.
• Up to 10 nozzles can be registered per 1 nozzle line.
• Even if you use this function, time required for printing does not change.
• For the lowest number of paths of the printing mode, the NOZZLE RECOVERY function is invalid.
• Even if you register the NOZZLE RECOVERY, the pattern of test print etc. is not recovered.
• When you use white ink, print on the clear film to check.
SELECT NOZZLE
:H1-A
Head No.: H1 or
Nozzle line: A,B,C,D
H1 - A
No.1:184
Registration No.: 1 to 10
Recovery nozzle No.
(1 to 320) or OFF
Nozzle missing
No.184
Nozzle
number
Nozzle missing
No.16
Nozzle
missing
No.128
Registration
number
Recovery
Nozzle No.
State
116
Target for nozzle recovery
2 128
Target for nozzle recovery
3 184
Target for nozzle recovery
4 OFF
No registration
5OFF
No registration
Example of nozzle to be recovered