Ionizer maintenance
4-41
1
1
1
4
Routine Maintenance
Installing the Filter
Explain the filter exchange method of Electrode Probe Cleaning Kit (SPA-0237).
1
Remove the used filter and insert the new filter
into the hole at the center of the electrode probe
cleaning kit.
• Be careful of the way the filter is facing. Install the filter with
the hole side up.
2
Push the filter all the way into the cleaning kit.
• Mounting position of the filter to be set in ±1mm to the end
faces.
• Push the filter completely inside to prevent it from bending.
Cleaning Kit Replacement Filter
• After the filter is used to clean multiple electrode probes, dust becomes attached to the filter and the
cleaning abilities are reduced.
• If the filter is dirty, replace with Electrode Probe Cleaning Kit included instead filter or exchange for
optional cleaning kit of filters, (SPC-0238).
To Next Page
Loading...
