MIMAKI JFX200-2531 - Page 156

5-10
Message Cause Solution
The value of the negative pressure
sensor is abnormal.
• Perform “PRESSURE ADJUST” ( P.5-
7) of the maintenance. If you cannot adjust
it to the normal value, or, even if you per-
form, it may be displayed, contact your
local distributor to call for service.
The value of the positive pressure sen-
sor is abnormal.
The ink of the ink bottle has been
nearly used up.
There is little ink in the supply unit.
• Press the key to check the rele-
vant ink bottle. Be careful because it may
be INK NEAR END soon.
Ink could not be supplied to the sub
tank.
• Perform “SUB TANK” ( P.5-6) of the
maintenance. Also check the remaining
amount of ink in the ink bottle. Even if you
performed this, when the message is dis-
played, contact your local distributor to call
for service.
The liquid level sensor abnormality of
the sub tank has been detected.
• Turn off the power to the machine and turn
it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
Overflow from the sub tank has been
detected.
• Perform “SUB TANK” ( P.5-11) of the
maintenance. Even if you performed this,
when the message is displayed, contact
your local distributor to call for service.
Though a certain amount was con-
sumed, there is no change in the sub
tank sensor High.
Though a certain amount was con-
sumed, there is no change in the sub
tank sensor Low.
The machine temperature is high.
Adjust the ambient temperature of the
installation place.
The machine temperature is low.
The supply pump in the ink path shall
be replaced soon.
• The supply pump shall be replaced.
Contact a distributor in your district, our
office, or our call center.
The suction pump in the ink path shall
be replaced soon.
• The suction pump shall be replaced.
Contact a distributor in your district, our
office, or our call center.
Time to replace the brush of Y motor
has come.
• The brush of Y motor shall be replaced.
Contact a distributor in your district, our
office, or our call center.
<LOCAL>
NEGAT I VE PRESSURE
<LOCAL>
POS I T I VE PRESSURE
<LOCAL>
INK NEAR END [ENT]
<LOCAL>
SUPPLY I NK : MMCCYYKK
<LOCAL>
Sub t ankSens :MMCCYYKK
<LOCAL>
I n kOv e r f l ow : MMCCYYKK
<LOCAL>
TANK l e v r l H : MMCCYYKK
<LOCAL>
TANKlevrlL :MMCCYYKK
<LOCAL>
Ma c h i n e TEMP / H i * * *
 C
<LOCAL>
Ma c h i n e TEMP / L o * * *
 C
<LOCAL>
Replace SupplyPUMP
<LOCAL>
Rep l ace Suc t i onPUMP
<LOCAL>
Rep l a c e Ymo t o r B r u s h