MIMAKI JFX200-2531 - Page 31

Setting ink bottles
1-13
1
Before Use
3
4
5
6
5
Move the lever on the tank completely from the
right to the left side.
6
Insert the IC chip.
• Insert the IC chip with the left side with metal upward. If you
insert the wrong side by accident, it causes faulty or
damage of the IC chip.
• Do not touch the metal part of the IC chip. It may break the
IC chip by static, or may cause read error by stain or flaw.
• For the setting orders of the ink bottles, refer to P.6-4.
About IC chip
• The IC chip has information of ink color, remaining amount of ink, expiration data, etc.
When setting the ink bottle, insert the IC chip packed with the ink bottle into the IC chip inserting port
attached with the ink cover.
• If you set the IC chip not being the pair of the ink bottle, image quality defect etc. may occur.
• The mark indicating color information is pasted on the IC chip.
IC chip
Ink color and indication mark
Ink color Indication mark
Black
(one black circle)
Cyan
(one blue circle)
Magenta
(one red circle)
Yell ow
(one yellow circle)
Ligth cyan
(one blue circle)
Light magenta
(one red circle)
White
(one white circle)
Clear
(two white circles)
Primer
(three white circles)
IC chip
Mark indication position