MIMAKI JFX200-2531 - Chapter 2 Basic Operations

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-4
Setting a Media .............................................2-5
Setting the Media ........................................ 2-5
Move the irradiation position of the UV
lamp ..............................................................2-8
Test Printing ................................................2-13
Test Printing .............................................. 2-14
Head Cleaning ............................................2-15
About head cleaning ..................................2-15
Perform head cleaning depending on
the test printing result ................................2-15
Printing Data ...............................................2-16
Starting a Printing Operation .....................2-16
Stopping a printing operation halfway ........2-17
Deleting Received Data (Data Clear) ........2-17
Move the Y-bar ..........................................2-18
Chapter 2
Basic Operations