MIMAKI JFX200-2531 - Page 43

2-7
1
2
Basic Operations
4
5
6
Setting a Media
About the media guide hole
There are guide holes into which the attached positioning pin is inserted at the position shown below. Use
these as a guide to set the media straight.
• You can attach the M3 screw in the marketplace instead of the attached positioning pin. In this case,
you can attach the screws in two locations at the left and front of the table.
• If you use the attached positioning pin, you cannot use the media of 5mm thickness and below.
• If you print onto media that is no more than 5 mm thick, make sure that the positioning pin has been
removed from the table.
Hole for attaching positioning pin
Hole for attaching M3 screw
Printing aera
Positioning pin
Origin (0,0)
Origin (0,0)
Positioning pin
Printing aera
Hole for attaching positioning pin
Hole for attaching M3 screw