MIMAKI JFX200-2531 - Page 69

Toggle Printing
3-15
1
1
3
Convinient use
5
6
Adjust head gap with the [UP] or [DOWN] keys
1
Press the or key.
2
Press to select the area to set the value.
3
Press the key.
4
Adjust with pressing the or key.
5
Press the key.
• For the setting procedure when the toggle print function is set to OFF, refer to P.3-4 "Adjust head gap
with the [UP] or [DOWN] keys".
• When [[F]/[R] SETUP] is set to "COMMON", the set value is registered to both FRONT/REAR areas.
AREA
:FRONT
AREA
:REAR
<REAR> OR I GI N SETUP
ZHEIGHT= 1.0mm
<REAR> OR I GI N SETUP
ZHEIGHT= 10.5mm
<REAR> OR I GI N SETUP
HEAD GAP = 1 . 5mm
<REAR> OR I GI N SETUP
MED I A t = 1 0 . 5 mm