30
Procedures
1
Press the key for about one second.
The load display will show “FUNC”.
2
Press the key three times.
It will make the load display proceed as
“FUNC”→“CCAL”→“ACAL”→“LCAL”.
3
Press the key.
“LCAL” mode can be entered, then the load
display will show “SCAL”.
4
Press the key.
The load display shows “D−01”.
When the calibration has completed already, the
set value of minimum scale registered at that
time will be displayed.
Set the minimum scale with the right keys.
Setting value for the minimum scale will be 4
(four) as follows：
1, 2, 5, 10
key ：Set value inclement key
5
Press the key.
The load display will show “DISP”.
To Next Page
Loading...
