Minebea CSD-701B - 5−2−4. Zero Fine Adjustment

35
5−2−4. Zero fine adjustment
(1) Procedures by key operation
 ● During the Tare weight cancellation(A/Z) or Zero set is executed, and
also during effective for Zero tracking and Peak ON, Zero fine
adjustment mode can’t be entered into. (Displays ER−5.)
The Zero fine adjustment can be entered after Tare weight
cancellation clear(A/Z OFF), cancellation of the Compensated data at
Zero set (Execution of F−98), set OFF the Zero tacking (Set the
F−08 and F−09 to “00000”.) and set the Peak OFF.
● During the calibration procedure, press the  key to interrupt the
calibration. The calibration data will keep the same condition as it is
entered before, then returns to the Measurement mode.
● When the  key is pressed with the load display of “FUNC”, the
display will change as the following arrow marks indicate at every
time the key is pressed. However, every time the  is pressed, the
display will change as the reverse direction of the following arrow
marks.
“FUNC”→“CCAL”→“ACAL”→“LCAL”→“ZERO”→“SPAN”
→“TARE”→“CHEK”→“MONT”→“VCAL”→“VADJ”→“FUNC”
→“CCAL”→･････(Hereinafter, it will repeat.)
Procedures
1
Press the  key for about one second.
The load display will show “FUNC”.
2
Press the  key four times.
It will make the load display proceeded as
“FUNC”→“CCAL”→“ACAL”→“LCAL”
→“ZERO”.
Here, set the initial load application.