36
Procedures
3
Press the key.
Zero fine adjustment mode can be entered, then
the display on load display will show the present
load value and lights on and off. At the same
time, set the present load value to “0” with the
right keys.
The variation of load value for one push of
the right key is less than 1 digit of display.
Therefore, a few pushes of these keys are
required to get the change of 1 digit of
display value.
It can be increased continuously by the
continuity press of the key.
key ：Zero fine adjustment
display decreasing key
key ：Zero fine adjustment
display increasing key
4
Press the key.
The indication of load display will show “END”.
Press the key.
After quitting from zero fine adjustment mode,
the load display will show the present load value.
To Next Page
Loading...
