47
6−2−2. Operation is made in another mode
(1) Carrying up the set value.
By pressing the
key with the condition of displaying various kinds of set values, the
flashing digits for set value will carry up from 10
0
,10
1
,10
2
,10
3
to 10
4
in order.
(However, the range of carry differs depending on the number of digits of set values and yes/no
of polarity sign.)
(2) Change of function and so on.
Executes change of various kinds of functions in Function mode, and also change of function
during Check mode.
(3) Decrement at the time of fine adjustment.
When the
key is pressed at the time of making fine adjustment on ZERO, SPAN and
analog output, the targeted value will decrease.
● In the operation method of the paragraph 6−2−2(3), when the key is
pressed for more than about 1 second, each operation will be executed
continuously at a constant interval without ON/OFF operation of the
key.
6−3. key
6−3−1. When operated in the Measurement mode.
(1) When it is operated alone.
At the same time the LED for S2 is flashing on and off, the Comparator S2 set value will
display and the 10
0
digit will flash on and off that makes to possible to set the set value for
Comparator S2. And if you keep the instrument untouched for approx. 20 seconds, the
Measurement mode can be re−entered automatically. Pressing the key makes to register
the set values internally, then the condition of “Possible to set value for S2” can be over.
(2) When it is operated while the press of
key.
If you operate while the press of
key, the zero set function works by this operation when
the display value in the load display section is within 10 % of the maximum indicated value
(Refer to the paragraph 5) and makes the display “0” compulsorily.
Please refer to details by the paragraph 7−12.
To Next Page
Loading...
