Minebea CSD-701B - Table of Contents; Index

INDEX
Forwards Ⅰ.......................................................
Marks and arrangements used in this manual Ⅱ....................................
For safe operation Ⅲ............................................................
1. Installation place Ⅲ.........................................................
2. Power supply Ⅴ............................................................
3. Application note Ⅴ.........................................................
History of revision Ⅶ............................................................
1. General 1.................................................................
1−1. Features 1............................................................
2. Name and function of each point 2..........................................
2−1. Front panel 2.........................................................
2−2. Rear panel 3..........................................................
3. Installation procedures 4...................................................
3−1. Installation place 4....................................................
3−2. Location where installation is not allowed. 4.............................
3−3. Installation 5.........................................................
3−4. Applicable environment 6..............................................
4. Connecting method 7......................................................
4−1. Layout of the terminal boards 7.........................................
4−2. Note on connection 8..................................................
4−3. Connection 9..........................................................
4−3−1. Connection with strain gage applied transducers 9..................
4−3−2. Connection with external control inputs 13..........................
4−3−3. Connection with contact outputs 14.................................
4−3−4. Connection with the power supply and the earth 15...................
4−3−5. Connection with analog outputs 16.................................
5. Calibration procedures 18...................................................
5−1. Preparations 18........................................................
5−2. Calibration procedures 18...............................................
5−2−1. Calibration method to register the output of strain gage applied transducer
at the time of maximum display after setting the load to zero 19........
5−2−2. Calibration procedures to register the output of strain gage applied
transducer at the time of zero and the maximum display 24............
5−2−3. Calibration method to register by reading output value of
strain gage applied transducer in the conditions of
zero/actual load application individually 29..........................
5−2−4. Zero fine adjustment 35............................................
5−2−5. Span fine adjustment 37...........................................
5−2−6. Calibration procedure to apply registration again for zero point only 39
5−3. Selection of calibration methods on each condition 41......................
5−3−1. In case of executing the calibration on the instrument newly. 41.......
5−3−2. When the calibration is executed again. 45...........................
5−4. Setting the prohibition against calibration 45..............................
6. Operation procedure 46.....................................................
6−1.
 key 46............................................................
6−1−1. Operations in Measurement mode 46...............................
6−2.
 key 46............................................................