Minebea CSD-701B - Page 11

6−2−1. When operating in the measurement mode 46........................
6−2−2. Operation is made in another mode 47..............................
6−3.
 key 47............................................................
6−3−1. When operated in the Measurement mode. 47........................
6−3−2. When operated in another modes 48................................
6−4.
 key 48............................................................
6−4−1. When operated in the Measurement mode. 48........................
6−4−2. When operated in another modes 48................................
6−5.
 key 49............................................................
6−5−1. When operated in the Measurement mode 49........................
6−5−2. When operated in another modes. 49................................
6−6.
 key 49............................................................
7. Function and operation 50...................................................
7−1. External control input signal and contact output signal 50..................
7−1−1. Input signal for external control 50.................................
7−1−2. Contact output signal 51...........................................
7−1−3. Equivalent circuit 51..............................................
7−2. Comparator 52.........................................................
7−2−1. ON/OFF of comparator S1 and S2 52................................
7−2−2. Change of set value 52.............................................
7−2−3. Operation on comparator S1 and S2 54..............................
7−2−4. Comparative target for comparator S1 and S2 55.....................
7−2−5. Hysteresis on comparator 56.......................................
7−3. How to use the filter 58.................................................
7−3−1. Digital filter 58...................................................
7−4. Zero tracking 58........................................................
7−4−1. What is zero tracking? 58..........................................
7−4−2. Setting related with zero tracking. 59...............................
7−4−3. Cancellation for compensation by zero tracking 59...................
7−5. Stabilized filter 60
......................................................
7−5−1. What is the Stabilized filter? 60.....................................
7−5−2. Setting related with the Stabilized filter. 60..........................
7−6. Change of Peak function and A/Z function 61..............................
7−7. How to use the peak hold. 62.............................................
7−8. Various functions concerning display 63..................................
7−8−1. Selection of target of display 63.....................................
7−8−2. Selection of position of decimal point display 63......................
7−8−3. Load display range 63.............................................
7−9. Selection the target for HOLD 63.........................................
7−10. Change of bridge power supply voltage 64.................................
7−11. Tare weight cancellation (A/Z) 64........................................
7−12. Zero set 64.............................................................
7−13. Lock of key function 65.................................................
7−14. CHECK value 65.......................................................
7−15. How to use the analog output 66.........................................
7−15−1. Scaling of analog output 66........................................
7−15−2. Fine adjustment 1 on analog output 67..............................
7−15−3. Fine adjustment 2 on analog output 70..............................