Minebea CSD-701B - Page 12

7−15−4. Selection of the target of analog output 72...........................
7−16. Memory location for setting data and so on 72.............................
7−17. Prohibition of calibration 72.............................................
7−18. Check mode 73.........................................................
7−18−1. Operating procedure for the check mode 73..........................
7−19. Monitor mode 78.......................................................
8. Function mode 80..........................................................
8−1. Setting method for function mode 80.....................................
8−2. Function of Function data 82............................................
9. Options 88.................................................................
9−1. Current output 88......................................................
9−1−1. Related functions 88..............................................
9−1−2. Specifications for the current output 88.............................
9−2. BCD output 89.........................................................
9−2−1. Related function 89...............................................
9−2−2. Specifications for BCD output 89...................................
9−2−3. Pin configurations for the BCD output connector 89..................
9−2−4. Equivalent circuit for input/output 90...............................
9−2−5. Timing chart 91..................................................
9−2
−6. Output condition 92...............................................
9−2−7. Selection of output logic for P.C.(Print command),
and selection of its width 93........................................
9−3. RS−232C interface 94..................................................
9−3−1. Related function 94...............................................
9−3−2. Specifications for interface 94......................................
9−3−3. Procedures of data transfer 95......................................
9−3−4. Pin configurations for connector pin 96.............................
9−3−5. Data format 97...................................................
9−3−6. Communication error process 100...................................
9−4. RS−422 interface 101....................................................
9−4−1. Related functions 101..............................................
9−4−2. Specifications on interface 102......................................
9−4−3. Procedure of data transmission 102..................................
9−4−4. Pin layout and wiring of Connector 103..............................
9−4−5. Data format 104...................................................
9−4−6. Process of communication error 106.................................
9−5. Serial interface 107......................................................
9−
5−1. Related function 107...............................................
9−5−2. Specifications for Interface 107......................................
9−5−3. Connecting method and internal equivalent circuit 108................
9−5−4. Data format 109...................................................
9−5−5. Explanation of format data 110......................................
9−5−6. Explanation of output type 110......................................
9−6. Power supply voltage DC12 V(CSD701B−P66) 111........................
9−6−1. Layout of the terminal boards 111...................................
9−6−2. Connection with the power supply and the earth 112...................
9−7. Power supply voltage DC24 V(CSD701B−P67) 113........................
9−7−1. Layout of the terminal boards 113...................................
9−7−2. Connection with the power supply and the earth 114...................
10. Trouble shooting 115........................................................