Mitsubishi Electric MELSEC iQ-F Series - Page 308

306
APPX
Appendix 8 Connection Method for MR-J5(W)-G
3. Set the transfer range between the link device of the set station and the CPU module device.
[Navigation window]  [Parameter]  [Module Information]  Target module  [Module Parameter (Network)]  [Basic
Settings]  [Refresh Setting]
4. Operate the link device that corresponds to each object.
(1) Select [Refresh Setting].
(2) Set the start and end of the link device so as to align them with the station to be used.
(3) Set the link device transfer destination.
(4) Set the start of the transfer destination device for the link device.
(5) After the network configuration settings and refresh settings are completed, click the [Apply] button.
(4)
(5)
(1)
(2)
(3)