Mitsubishi Electric MELSEC-Q/L - Page 1035

APPENDICES
Appendix 1 Operation Processing Time
1033
A
Processing time of instructions other than subset instruction
The following table shows the processing time of instructions other than subset instructions.
• The processing time shown in "Table of the processing time of instructions other than subset instructions"
applies when the device used in an instruction does not meet the device condition for subset processing.
(For device condition that does not trigger subset processing, refer to Page 108 Subset processing.) For
instructions not shown in the following table, refer to Page 1025 Subset instruction processing time.
• When using the file register (R, ZR), extended data register (D), extended link register (W), module access
device (Un\G), or link direct device (Jn\), add the processing time shown in Page 1063 Table of the time
to be added when file register, extended data register, extended link register, module access device, and
link direct device are used to that of each instruction.
• Since the processing time of an instruction varies depending on that of the cash function, both the minimum
and maximum values are described in the table.
■Table of the processing time of instructions other than subset instructions
• When using L02SCPU, L02SCPU-P, L02CPU, L02CPU-P, L06CPU, L06CPU-P, L26CPU, L26CPU-P, L26CPU-BT, and
L26CPU-PBT
Category Instruction Condition (device) Processing time (s)
L02SCPU, L02SCPU-
P
L02CPU, L02CPU-P L06CPU, L06CPU-P,
L26CPU, L26CPU-P,
L26CPU-BT, L26CPU-
PBT
Min. Max. Min. Max. Min. Max.
Sequence
instruction
ANB
ORB
MPS
MRD
MPP
 0.060 0.040 0.0095
INV When not executed 0.060 0.040 0.0095
When executed
MEP
MEF
When not executed 0.060 0.040 0.0095
When executed
EGP
EGF
When not executed 0.060 0.040 0.0095
When executed
PLS  1.800 1.900 1.600 1.700 0.890 1.200
PLF  1.800 1.900 1.600 1.700 0.890 1.200
FF When not executed 0.120 0.080 0.0185
When executed 1.700 1.800 1.500 1.500 0.790 0.910
DELTA When not executed 0.120 0.080 0.0185
When executed 4.000 14.700 2.700 6.800 2.400 3.200
SFT When not executed 0.120 0.080 0.0185
When executed 1.800 12.600 1.700 4.300 1.100 2.700
MC  0.120 0.080 0.0185
MCR  0.060 0.040 0.0185
FEND
END
Error check performed 280.000 220.000 180.000
No error check performed
STOP  
NOP
NOPLF
PAGE
 0.060 0.040 0.0095