Mitsubishi Electric MELSEC-Q/L

To Next Page

To Previous Page

470

7 APPLICATION INSTRUCTIONS

7.6 Structure Creation Instructions

• When function devices (FX, FY, FD) are used by a subroutine program, specify a device with (S1) to (S5) corresponding to

the function device. The contents to the devices specified by (S1) to (S5) are as indicated below.

*1 An error will not occur even when the device number specified by (S1) to (S5) is not a multiple of 16 at the digit designation of the bit

device.

[Main routine program]

• The FCALL (P) instruction can use from (S1) to (S5).

• Up to 16 nesting levels are possible with the FCALL(P) instruction. However, this 16 levels is the total number of levels in

the CALL(P), FCALL(P), ECALL(P), EFCALL(P), and XCALL instructions.

• Prior to execution of the subroutine program, bit data is transmitted to FX, and word data is transmitted to FD.

• After the execution of the subroutine program, the contents of FY and FD are transmitted to the corresponding devices.

• The function devices FX and FY are processed in units of bits. The function device FD is processed in units of 4 words. The size of the data to be dealt with

will differ depending on the device specified in the argument. The device specified as a function device should be secured for the data size. An error will occur

if it cannot be secured for the data size.

Function devices Device Data size Remark

•FX

•FY

Bit device 1 point 

When bit designation has been made

for word device

1 bit

• FD When digit designation of a bit device

is used

4 words The upper 2 words of FD become 0.

Word device 4 words 