M800S/M80/E80 Series Connection and Setup Manual
32 SRAM Open Parameter Screen
556
IB-1501269-J
Menu when inputting the display format
Menu Details
Change the display format to the decimal format with sign.
Change the display format to the decimal format without sign.
Change the display format to the hexadecimal format.
Change the display format to the BIT format.
Change the display format to the BCD format.
Change whether to show the group detail screen to the users.
Change whether the input protection check is valid or not.
Delete a group of the line where a cursor is placed.
Copy the data of a line where a cursor is placed.
Writes the contents of the data copied (one line) into the line where the cursor is placed.
If the data of the line is changed after [Line copy] is pressed, the data before change will be written when
pasting it.
Once the line is copied, it can be pasted many times until new area is copied.
Clears all allocation of the parameter in the SRAM open parameter screen.
(Note) Data of the group detail will not be cleared.
When parameter No. is set and [INPUT] key is pressed, the group will be displayed with the set parameter
No. set at the top of the group.
A cursor moves to the line of the target group.
The group detail screen corresponding to the group where a cursor is placed will be displayed.
When the group information, where a cursor is placed, is not set, it will be invalid.
To Next Page
Loading...
Need help?
General
