Mitsubishi M80 series User Manual

M800S/M80/E80 Series Connection and Setup Manual
35 Appx.2: Protection Setting
569
IB-1501269-J
Data to be protected
Display items Objects to be protected
Initial value Setting range
Change Output Change Output Change Output
Available level
Table for protection level setting on this screen
Table for protection level setting cannot be changed by the
operation level which is lower than the set protection level.
○
-4-4-6-
Tool data
Tool management data
Tool registration
Tool life management data
○
-
000-60-6
All tool data files (TOOLALL.DAT)
Tool life management data files (TLIFE.TLF)
Tool management data files (TOOLMNG.DAT)
○○
Tool offset data
Tool compensation amount data
Tool measurement data
○
-
000-60-6
Tool offset data files (TOOL.OFS)
○○
Workpiece offset
data
Coordinate system offset data
Workpiece installation error compensation data
Workpiece position offset for rotary axis
Workpiece measurement data
○
-
000-60-6
Workpiece offset data files (WORK.OFS)
○○
Workpiece shift data
Workpiece shift data
○
-
000-60-6
All tool data files (TOOLALL.DAT)
○○
User parameter data
User parameter data
Barrier data
○
-
000-60-6
Parameter files (ALL.PRM)
○○
Machine parameter
data
Machine parameter data
Device open parameter data
SRAM open parameter data
Spatial error compensation data file (POSTURE.DAT)
○
-
600-60-6
Parameter files (ALL.PRM, AUXAXIS.PRM, SYSTEM.PRM,
DEVOPEN.DAT, SRAMOPEN.DAT, DEVICENT.PRM)
Interfering data (OBSTACL.DAT)
R register data (RREG.REG)
Spatial error compensation data file (POSTURE.BIN)
○○
Pitch error
compensation
parameter
Error compensation parameter data
Error data
○
-
600-60-6
Parameter files (ALL.PRM)
○○

Mitsubishi M80 series Specifications

General

Type	CNC Control Unit
Power Supply	24V DC
Interpolation	Linear, circular, helical
Fieldbus	CC-Link
Operating Temperature	0 to 45°C
Interface	USB, RS-232
Processor	RISC processor
Ethernet	Yes (100BASE-TX/10BASE-T)