Mar. 2018 IB(NA)1501269-G The descriptions were revised in response to MITSUBISHI CNC E80 Series.
- The following units were added.
FCU8-MU513 (Control unit)
FCU8-MU514 (Control unit)
FCU8-DU121-13 (Display unit)
FCU8-KB024 (Keyboard unit)
FCU8-KB025 (Keyboard unit)
FCU8-DX731 (Operation panel I/O unit)
FCU8-DX409 (Remote I/O unit)
FCU8-EX564 (Communication expansion unit)
FCU8-KB925 (MITSUBISHI CNC Machine operation panel)
FCU8-KB926 (MITSUBISHI CNC Machine operation panel)
FCU8-KB941 (MITSUBISHI CNC Machine operation panel)
- The following cable was added.
J225 (Analog output cable)
- The following chapters were added.
2.3 General Connection Diagram [E80]
3.3 Control Unit [E80]
3.6 Display Unit [E80]
3.9 Keyboard Unit [E80]
3.12 Remote I/O Unit [E80]
3.18 MITSUBISHI CNC Machine Operation Panel [E80]
4.3 Environment Conditions [E80]
4.6 Control Unit [E80]
4.9 Display Unit [E80]
4.10.9 Keyboard for 8.4-type Display Unit (FCU8-KB024)
4.10.10 Keyboard for 8.4-type Display Unit (FCU8-KB025)
4.14.3 CC-Link IE Field (FCU8-EX564)
7.11.3 Connecting I/O Device via CC-Link IE Field
9.8 Connecting with Analog Output Signal (FCU8-DX731)
10.11 Connecting with Multi-analog Input Signal (FCU8-DX409)
15.2.18 J225 Cable
- The following contents were changed.
2 General Connection Diagram
3.10 Operation Panel I/O Unit
3.11 Remote I/O Unit [M800S/M80]
3.14 Communication Expansion Unit
3.17 MITSUBISHI CNC Machine Operation Panel [M800S/M80]
3.20 Cable Connector Sets
3.25 List of Cables
4.1.1 Installation Environment Conditions
4.2.1 Installation Environment Conditions
4.10 Keyboard Unit
4.11 Operation Panel I/O Unit
4.12 Remote I/O Unit
4.14.1 CC-Link (FCU8-EX561)
4.14.2 PROFIBUS-DP (FCU8-EX563)
4.14.4 EtherNet/IP (FCU8-EX565)
4.17.1 Main Panel A , B (FCU8-KB921 / FCU8-KB922 / FCU8-KB925 , FCU8-KB923 /
FCU8-KB924 / FCU8-KB926)
4.17.2 Sub Panel A (FCU8-KB931 / FCU8-KB941)
(Continue to the next page)
Date of
revision
Manual No. Revision details
To Next Page
Loading...
Need help?
General
