4 - 2
Chapter 4 Installation, Wiring and Maintenance of the Produc
4.1 Outline of installation, wiring and maintenance
4.1.1 Installation, wiring and maintenance procedures
The outline and procedures for QD77MS installation, wiring and maintenance are
shown below.
Refer to Section 4.5 "Maintenance".
Refer to Chapter 6 "Sequence Program Used for
Positioning Control".
Refer to Section 4.2 "Installation".
Checking wiring
Check wiring with GX Works2.
Start
Module mounting
Mount the QD77MS to the base unit.
Wiring
Connect external devices to the QD77MS.
Perform parameter
and data setting with
GX Works2?
YES
NO
Parameter setting and auto refresh setting
Perform each setting with GX Works2.
Programming and debugging
Create and debug sequence programs.
Start operation
Maintenance
End
Refer to Section 4.3 "Wiring".
Refer to Section 4.4 "Confirming the installation and wiring".
Refer to the "Simple Motion Module Setting Tool Help" of
GX Works2.
To Next Page
Loading...
Need help?
General
