Appendix - 59
Appendices
Appendix 5 When using GX Works2
Use the "Simple Motion Module Setting Tool" for QD77MS various setting.
The following shows the procedure for positioning operation when GX Works2 is used.
START
Starting GX Works2
Start GX Works2.
Creating a new project
Create a new project with GX Works2.
Adding a module
Add a module for the project of GX Works2.
System setting and auto refresh setting
Configure each setting with GX Works2.
Adding a module for the project of Simple
Motion Module
Add a module for the project of Simple Motion
Module Setting Tool.
Creating a new project of Simple Motion Module
Create a new project with Simple Motion
Module Setting Tool.
Starting Simple Motion Module Setting Tool
Start Simple Motion Module Setting Tool with
GX Works2.
Configure parameters
and positioning data with
GX Works2 ?
Parameter setting
Configure each setting with GX Works2.
YES
NO
Programming and debugging
Create and debug a sequence program.
Starting operation
Writing data to flash ROM
Write data to the flash ROM.
END
Refer to "Chapter 6".
Creating programs for parameters and data
Create programs to set parameters and data.
Refer to "Chapter 6".
Positioning test
Execute a test operation such as positioning
data etc.
For details on the operation method of GX Works2, refer to the "GX Works2
Version1 Operating Manual (Common)" or " GX Works2 Version1 Operating
Manual (Intelligent Function Module)".
For details on the operation method of Simple Motion Module Setting Tool,
refer to the "Simple Motion Module Setting Tool Help" of GX Works2
(Note-1)
(Simple Motion Module Setting Tool).
(Note-1): GX Works2 version 1.48A or later.
To Next Page
Loading...
Need help?
General
