5 - 26
Chapter 5 Data Used for Positioning Control
5.2.3 Detailed parameters 1
Setting value, setting range
Setting value buffer memory
address
Item
Value set with GX Works2
Value set with sequence
program
Default value
QD77MS2
QD77MS4
QD77MS16
Pr.11
Backlash compensation
amount
0 17+150n
Pr.12
Software stroke limit
upper limit value
2147483647
18+150n
19+150n
Pr.13
Software stroke limit
lower limit value
The setting value range differs according to the "
Pr.1
Unit
setting".
–2147483648
20+150n
21+150n
0 : Apply software stroke limit on
current feed value
0
Pr.14
Software stroke limit
selection
1 : Apply software stroke limit on
machine feed value
1
0 22+150n
0 : Software stroke limit valid
during JOG operation, inching
operation and manual pulse
generator operation
0
Pr.15
Software stroke limit
valid/invalid setting
1 : Software stroke limit invalid
during JOG operation, inching
operation and manual pulse
generator operation
1
0 23+150n
Pr.16
Command in-position
width
The setting value range differs depending on the "
Pr.1
Unit
setting".
100
24+150n
25+150n
Pr.17
Torque limit setting value
1 to 1000 (%) 1 to 1000 (%) 300 26+150n
0 : WITH mode 0
Pr.18
M code ON signal output
timing
1 : AFTER mode 1
0 27+150n
0 : Standard speed switching
mode
0
Pr.19
Speed switching mode
1 : Front-loading speed switching
mode
1
0 28+150n
0 : Composite speed 0
Pr.20
Interpolation speed
designation method
1 : Reference axis speed 1
0 29+150n
0 : Do not update current feed
value
0
1 : Update current feed value 1
Pr.21
Current feed value
during speed control
2 : Clear current feed value to zero 2
0 30+150n
n: Axis No.-1
To Next Page
Loading...
Need help?
General
