Mitsubishi MELSEC-Q QD77MS - Block Start Data and Condition Data Configuration

10 - 4
Chapter 10 High-Level Positioning Control
10.1.2 "Block start data" and "condition data" configuration
The "block start data" and "condition data" corresponding to "block No. 7000" can be
stored in the buffer memory.
• QD77MS2/QD77MS4
26049+1000n
26099+1000n
50th point
Setting item
Buffer memory
address
26001+1000n
26051+1000n
2nd point
Setting item
Buffer memory
address
No.10
Setting item
Buffer memory
address
26192+1000n
26193+1000n
26194+1000n
26195+1000n
26196+1000n
26197+1000n
26190+1000n
No.2
Setting item
Buffer memory
address
26112+1000n
26113+1000n
26114+1000n
26115+1000n
26116+1000n
26117+1000n
26110+1000n
Da.16 Da.15Condition
operator
Condition
target
No.1
Setting item
Buffer memory
address
Condition data
b0b8b15
26102+1000n
26103+1000n
Da.17
Da.18
Da.19
26104+1000n
26105+1000n
26106+1000n
26107+1000n
Address
Parameter 1
Parameter 2
26100+1000n
b7
n: Axis No.-1
(Note): Set the block No. with sequence program or
GX Works2.
Block No.
7000
Low-order buffer memory
High-order buffer memory
26000+1000n
26050+1000n
1st point
Setting item
Buffer memory
address
Block start data
Da.11 Da.12Shape Start data No.
b0b7b8b15
Da.13
Da.14
Special start instruction
Parameter
b0b7b8b15