13 - 1
13
Chapter 13 Control Sub Functions
Chapter 13 Control Sub Functions
The details and usage of the "sub functions" added and used in combination with
the main functions are explained in this chapter.
A variety of sub functions are available, including functions specifically for machine
OPR and generally related functions such as control compensation, etc.
More appropriate, finer control can be carried out by using these sub functions.
Each sub function is used together with a main function by creating matching
parameter settings and sequence programs. Read the execution procedures and
settings for each sub function, and set as required.
13.1 Outline of sub functions ........................................................................................... 13- 2
13.1.1 Outline of sub functions .............................................................................13- 2
13.2 Sub functions specifically for machine OPR........................................................... 13- 4
13.2.1 OPR retry function...................................................................................... 13- 4
13.2.2 OP shift function ........................................................................................ 13- 8
13.3 Functions for compensating the control.................................................................13- 11
13.3.1 Backlash compensation function..............................................................13- 11
13.3.2 Electronic gear function ............................................................................13- 13
13.3.3 Near pass function ....................................................................................13- 21
13.4 Functions to limit the control...................................................................................13- 23
13.4.1 Speed limit function...................................................................................13- 23
13.4.2 Torque limit function..................................................................................13- 25
13.4.3 Software stroke limit function....................................................................13- 29
13.4.4 Hardware stroke limit function ..................................................................13- 35
13.4.5 Forced stop function .................................................................................13- 39
13.5 Functions to change the control details .................................................................13- 42
13.5.1 Speed change function .............................................................................13- 42
13.5.2 Override function.......................................................................................13- 49
13.5.3 Acceleration/deceleration time change function ......................................13- 52
13.5.4 Torque change function ............................................................................13- 57
13.5.5 Target position change function ...............................................................13- 61
13.6 Absolute position system........................................................................................13- 65
13.7 Other functions........................................................................................................13- 67
13.7.1 Step function .............................................................................................13- 67
13.7.2 Skip function..............................................................................................13- 72
13.7.3 M code output function..............................................................................13- 75
13.7.4 Teaching function......................................................................................13- 79
13.7.5 Command in-position function ..................................................................13- 85
13.7.6 Acceleration/deceleration processing function ........................................13- 88
13.7.7 Pre-reading start function .........................................................................13- 91
13.7.8 Deceleration start flag function .................................................................13- 94
13.7.9 Stop command processing for deceleration stop function.......................13- 97
13.7.10 Speed control 10 x multiplier setting for degree axis function ...............13- 100
13.7.11 Operation setting for incompletion of OPR function...............................13- 103
13.8 Servo ON/OFF......................................................................................................13- 105
13.8.1 Servo ON/OFF ........................................................................................13- 105
13.8.2 Follow up function ...................................................................................13- 107
To Next Page
Loading...
Need help?
General
