Mitsubishi MELSEC-Q QD77MS - Page 195

5 - 74
Chapter 5 Data Used for Positioning Control
(3) Parameters of MR-J3(W)- B
The parameter list for MR-J3(W)- B is shown below.
Refer to the "Servo amplifier Instruction Manual" for details of setting items.
Do not change other than the buffer memory addresses of the parameters
described in "Servo amplifier Instruction Manual".
Servo amplifier type Instruction manual name
MR-J3- B SSCNET interface MR-J3- B Servo amplifier Instruction Manual (SH-030051)
MR-J3W- B
SSCNET
interface 2-axis AC Servo amplifier MR-J3W- B Servo amplifier
Instruction Manual (SH-030073)
MR-J3- B-RJ004
SSCNET
Compatible Linear Servo MR-J3- B-RJ004 Instruction Manual
(SH-030054)
MR-J3- B-RJ006
SSCNET
Compatible Fully Closed Loop Control MR-J3- B-RJ006 Servo
amplifier Instruction Manual (SH-030056)
MR-J3- BS
SSCNET
interface Drive Safety integrated MR-J3- B Safety Servo amplifier
Instruction Manual (SH-030084)
POINT
Set the parameter value and switch power off once (The parameter is transferred to
servo amplifier from QD77MS), and then switch it on again to make that parameter
setting valid.