5 - 104
Chapter 5 Data Used for Positioning Control
• QD77MS4
Block
No. 1
Axis Block start data Condition Buffer memory GX Works2
Axis 1 Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
7000
Axis 4
Start block 0
Condition data (1 to 10)
Axis 1 Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
7001
Axis 4
Start block 1
Condition data (1 to 10)
Axis 1 Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
7002
Axis 4
Start block 2
Condition data (1 to 10)
Axis 1 Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
7003
Axis 4
Start block 3
Condition data (1 to 10)
Axis 1 Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
7004
Axis 4
Start block 4
Condition data (1 to 10)
Supports the
settings
Supports the
settings
• QD77MS16
Block
No.
1
Axis Block start data Condition Buffer memory GX Works2
Axis 1 Condition data (1 to 10)
to to
7000
Axis 16
Start block 0
Condition data (1 to 10)
Axis 1 Condition data (1 to 10)
to to
7001
Axis 16
Start block 1
Condition data (1 to 10)
Supports the
settings
Axis 1 Condition data (1 to 10)
to to
7002
Axis 16
Start block 2
Condition data (1 to 10)
Axis 1 Condition data (1 to 10)
to to
7003
Axis 16
Start block 3
Condition data (1 to 10)
Axis 1 Condition data (1 to 10)
to to
7004
Axis 16
Start block 4
Condition data (1 to 10)
Supports the
settings
1: Setting cannot be made when the "Pre-reading start function" is used. If you set any of
Nos. 7000 to 7004 and perform the Pre-reading start function, "Outside start No. range
error (error code: 543)" will occur.
(For details, refer to Section 13.7.7 "Pre-reading start function".)
To Next Page
Loading...
Need help?
General
