9 - 60
Chapter 9 Major Positioning Control
Positioning data setting example
[When "4-axis fixed-feed control (fixed-feed 4)" is set in positioning data No.1 of
axis 1]
• Reference axis............. Axis 1
• Interpolation axis.......... Axis 2, Axis3, Axis4 (The required values are also set in
positioning data No. 1 of axis 2, axis 3 and axis 4.)
QD77MS4 setting example QD77MS16 setting example
Axis
Setting item
Axis 1
(reference
axis)
Axis 2
(interpolation
axis)
Axis 3
(interpolation
axis)
Axis 4
(interpolation
axis)
Axis 1
(reference
axis)
Axis 2
(interpolation
axis)
Axis 3
(interpolation
axis)
Axis 4
(interpolation
axis)
Setting details
Da.1
Operation pattern
Positioning
complete
– – –
Positioning
complete
– – –
Set "Positioning
complete" assuming the
next positioning data will
not be executed.
Da.2
Control system
Fixed-feed
4
– – –
Fixed-feed
4
– – –
Set 4-axis fixed-feed
control.
Da.3
Acceleration time
No.
1 – – – 1 – – –
Designate the value set
in "
Pr.25 Acceleration time
1" as the acceleration
time at start.
Da.4
Deceleration time
No.
0 – – – 0 – – –
Designate the value set
in "
Pr.10 Deceleration time
0" as the deceleration
time at deceleration.
Da.5
Axis to be
interpolated
QD77MS4
– – – –
Setting not required
(setting value is ignored).
When axis 1 is used as a
reference axis, the
interpolation axes are
axes 2, 3 and 4.
Da.6
Positioning address/
movement amount
4000.0
μm
8000.0
μm
4000.0
μm
3000.0
μm
4000.0
μm
8000.0
μm
4000.0
μm
3000.0
μm
Set the positioning
address. (Assuming
"mm" is set in "
Pr.1 Unit
setting ".)
Da.7
Arc address – – – – – – – –
Setting not required
(setting value is ignored).
Da.8
Command speed
6000.00
mm/min
– – –
6000.00
mm/min
– – –
Set the speed during
movement.
Da.9
Dwell time 500ms – – – 500ms – – –
Set the time the machine
dwells after the
positioning stop
(command stop) to the
output of the positioning
complete signal.
Da.10
M code 10 – – – 10 – – –
Set this when other sub
operation commands are
issued in combination
with the No. 1 positioning
data.
Da.20
Axis to be
interpolated No.1
QD77MS16
Axis 2 – – –
Da.21
Axis to be
interpolated No.2
QD77MS16
Axis 3 – – –
Axis 1 Positioning data No. 1
Da.22
Axis to be
interpolated No.3
QD77MS16
Axis 4 – – –
Set the axis to be
interpolated.
If the self-axis is set, an
error will occur.
(Note): Refer to Section 5.3 "List of positioning data" for information on the setting details.
To Next Page
Loading...
Need help?
General
