MLC LC100 - Page 110

110
LC100 Instruction manual
NO
DYSPLAY ON LC100-D
DESCRIPTION
FO-095
Nudging output for door A.
FO-096
Nudging output for door B.
FO-097
Output function for start safety procedure for inspection drive in case of low
pit function (FI-308) didn’t occurred before switched off power supply.
FO-098
Forwarding information about Stopping UP & Stopping DOWN input.
FO-099
Output function which is activated when cabin load is less then 40 kg.
FO-100
Function for the unknown position of the cabin.
FO-101
Function cabin at floor 1.
FO-102
Function cabin at floor 2.
FO-1xx
Function cabin at floor XX.
FO-141
7-segment display (left)
FO-142
7-segment display (left)
FO-143
7-segment display (left)
FO-144
7-segment display (left)
FO-145
7-segment display (left)
FO-146
7-segment display (left)
FO-147
7-segment display (left)
FO-148
7-segment display (right)
FO-149
7-segment display (right)
FO-150
7-segment display (right)
FO-151
7-segment display (right)
FO-152
7-segment display (right)
FO-153
7-segment display (right)
FO-154
7-segment display (right)
FO-155
Output function, active when safety circuit are bridge.
FO-156
Output function, driving with bridged safety circuit, constantly signal.
FO-157
Output function, driving with bridged safety circuit, intermittent signal of=1Hz.
FO-158
Output function, UPS test (return information from FI-342).
FO-159
Output function for testing door locking.
FO-160
Output function, when function FI-205 are active
FO-161
Output function for turning ON shaft light.
FO-162
Output function for turning OFF shaft light.
FO-163
Output function for turning on emergency light, detected by
evacuation/LC100-VFD plate.
FO-164
When function FI-335 are active,
FO-165
Output function which is activated when input function FI-335 are activated.