Reference Tables
314 98-08901C68-O
S0 This S-parameter represents the number of rings before the g20 is answered
automatically.
187
S102 This command sets the value of the delay before sending the data to the terminal. 194
S24 This S-parameter activates/disables the Sleep mode. If the parameter value is
greater than 0, it represent the number of seconds till the g20 enters sleep mode.
193
S3 This S-parameter represents the decimal IA5 (International Alphabet No. 5) value of
the command line termination character that terminates an incoming command line.
187
S4 This S-parameter represents the decimal IA5 (International Alphabet No. 5) value of
the response formatting character that is generated by the g20 as part of the header,
trailer, and terminator for result codes and information text, along with the S3
parameter.
187
S5 This S-parameter represents the decimal IA5 (International Alphabet No. 5) value of
the command line editing character that the g20 recognizes as a request to delete
the immediately preceding character from the command line.
187
S94 This S-parameter represents the Boolean status, On/Off, of the sidetone feature. 160
S96 This S-parameter represents the Boolean status, On/Off, of the echo cancelling
feature.
161
T This command selects tone dialing. This command is used for backward
compatibility only.
226
V This command determines the response format of the data adapter and the contents
of the header and trailer transmitted with the result codes and information
responses.
181
X This command defines the data adaptor response set, and the CONNECT result
code format.
185
Y This command disconnects on long space.This command is used for backward
compatibility only.
226
Z This command resets the default configuration. 190
Table 137. AT Commands (Alphabetical) (Continued)
AT
Command
Description Page
To Next Page
Loading...
