Product Features
22 98-08901C68-O
+MTCTS This command sets the CTS pin of the RS232 to not active (high), waits one second
and then returns the CTS to active (low).
150
&K This command configures the RTS/CTS flow control. 150
+IPR This command is responsible for setting and saving the request baud rate. 151
&C This command determines how the state of the DCD line relates to the detection of
the received line signal from the distant end.
153
&D This command determines how the g20 responds when the DTR (Data Terminal
Ready) status is changed from ON to OFF during the online data state.
155
+MCWAKE This command requests reports on the status of the GPRS coverage. 156
Audio
Audio Tone Commands
+CRTT This command plays one cycle of a ring tone, stops the cycle in the middle, and sets
the ring tone to be used.
158
S94 This S-parameter represents the Boolean status, On/Off, of the sidetone feature. 160
S96 This S-parameter represents the Boolean status, On/Off, of the echo cancelling
feature.
161
+MA Audio Control Commands
+MAPATH This command sets/requests the active input accessory, and the output accessory
for each feature.
163
+MAVOL This command enables you to determine a volume setting for a particular feature in
a particular accessory.
165
+MAFEAT This command controls the various algorithm features, such as sidetone, echo
cancel and noise suppress.
167
+MAMUT This command controls the muting/unmuting of all input paths (MIC, HDST_MIC,
DIGITAL_RX).
169
Table 3. AT Commands (Continued)
AT
Command
Description Page
To Next Page
Loading...
