Product Features
28 98-08901C68-O
+MIPSEND This command causes the g20 to transmit the data that the terminal provides, using
an existing protocol stack.
253
+MIPPUSH This command causes the g20 module to push the data accumulated in its
accumulating buffers into the protocol stack.
254
+MIPFLUSH This command causes the g20 module to flush (delete) data accumulated in its
accumulating buffers.
255
+MIPRCV This command causes the g20 to send unsolicited events to the DRT when it detects
that data has arrived on the protocol stack.
257
+MIPSTAT This command sends an unsolicited event to the terminal indicating a change in link
status.
257
+MIPXOFF An unsolicited event that the g20 sends to the terminal to stop sending data. 258
+MIPXON An unsolicited event that the g20 sends to the terminal when the g20 has free
memory in the accumulating buffer.
258
Table 3. AT Commands (Continued)
AT
Command
Description Page
To Next Page
Loading...
