98-08901C68-O 27
Product Features
Fax Class 1
Fax Commands
+FCLASS This command places the TA into a particular mode of operation (data, fax, voice). 229
+FTS This command causes the DCE to stop any transmission) 230
+FRS This command causes the DCE to listen and to report back an OK result code when
the line has been silent for the specified amount of time.
231
+FTM This command causes the DCE to transmit data. 232
+FRM This command causes the DCE to enter the receive mode. 234
+FTH This command causes the DCE to transmit data framed in the HDLC protocol. 235
+FRH This command causes the DCE to receive HDLC framed data and deliver the next
received frame to the terminal.
236
Features
STK Commands
+MTKE This command enables/disables the SIM ToolKit functionalities. 238
+MTKP Pro-active. Unsolicited event, SIM ToolKit Pro-active event. 239
+MTKM Menu. Unsolicited event, SIM ToolKit Menu event. 243
+MTKC This command enables customer application outgoing calls or SMSs, CALL
CONTROL and SMS CONTROL responses to be identified, if the call control facility
is activated.
246
TCP/IP Commands
+MIPCALL This command creates a wireless PPP connection with the GGSN, and returns a
valid dynamic IP for the g20.
246
+MIPOPEN This command causes the g20 module to initialize a new socket and open a
connection with a remote side.
248
+MIPCLOSE This command causes the g20 module to free the socket accumulating buffer and
disconnect the g20 from a remote side.
250
+MIPSETS This command causes the g20 to set a watermark in the accumulating buffer. When
the watermark is reached, data is pushed from the accumulating buffer into the
protocol stack.
251
Table 3. AT Commands (Continued)
AT
Command
Description Page
To Next Page
Loading...
