ioLogik E2210 User’s Manual Using ioAdmin
3-6
Server Settings Tab (General)
The Server Settings tab is where you log in as an administrator. This is required in order to gain access to
the ioLogik E2210 configuration options. If no administrator password has been set up, simply click on
Login and leave the Password for entry field blank. Please refer to the ioAdmin Administrator Functions
section later on in this chapter for more detail.
Message Monitor Tab
The Message Monitor tab will display any TCP/UDP I/O messages received from the ioLogik E2210.
When you install the ioLogik E2210 for the first time, the active I/O messaging ruleset will not have been
defined yet, so there will be no messages in the Message Monitor Tab. Please refer to Chapter 5:
Click&Go Logic for information on how to program the ioLogik E2210’s active I/O messaging system.
Once the active I/O messaging system has been configured and activated, TCP/UDP messages sent from
the ioLogik E2210 will be viewable in the Message Monitor tab.
Messages can be displayed in ASCII or in HEX. To display messages in HEX, make sure that “Toggle
HEX” is checked.
To Next Page
Loading...
Need help?
General
