ioLogik E2210 User’s Manual Using the Web Console
4-2
Introduction to the Web Console
The ioLogik E2210 web console is a browser-based configuration utility. When the ioLogik E2210 is
connected to your network, you may enter the server’s IP address in your web browser to access the web
console. Note that although most configuration options are available in the web console, some settings are
only available through ioAdmin. Furthermore, the web console can be disabled under Web Access
Settings in ioAdmin. If you are unable to access the web console, check the Web Access Settings in
ioAdmin.
The left panel is the navigation panel and contains an expandable menu tree for navigating among the
various settings and categories. When you click on a menu item in the navigation panel, the main window
will display the corresponding options for that item. Configuration changes can then be made in the main
window. For example, if you click on Basic Settings in the navigation panel, the main window will show
a page of basic settings that you can configure.
You must click on the Submit button after making configuration changes. The Submit button will be
located at the bottom of every page that has configurable settings. If you navigate to another page without
clicking the Submit button, your changes will not be retained.
Submitted changes will not take effect until they are saved and the ioLogik E2210 is restarted! You
may save and restart the server in one step by clicking on the Save/Restart button after you submit a
change. If you need to make several changes before restarting, you may save your changes without
restarting by selecting Save/Restart in the navigation panel. If you restart the ioLogik E2210 without
saving your configuration, the ioLogik E2210 will discard all submitted changes.
Basic Settings
On the Basic Settings page, you may set the ioLogik E2210’s system time or provide the IP address of a
time server for time synchronization.
Main
Window
Navigation
Panel