ioLogik E2210 User’s Manual Introduction
1-3
Optional Liquid Crystal Display Module (LCM)
As a MOXA Easy View product, the ioLogik E2210 supports an optional hot-pluggable Liquid Crystal
Display Module (LCM) for field management and configuration. The LCM can display network and I/O
settings such as digital input mode and value. The ioLogik E2210’s IP address and netmask may also be
configured using the LCM, and one LCM can be used to maintain and configure all your Easy View
devices.
Product Features
z Click&Go logic builder for easy configuration of your Active Ethernet I/O system
z High-speed active I/O messaging
z 12-channels of 24 Vdc digital input (DI) with DI/Event Counter mode and software selectable
filtering time
z 8-channels of 24 Vdc digital output (DO) with Pulse Output mode and software selectable pulse
width
z 10/100 Mbps Ethernet with Modbus/TCP protocol connecting up 10 hosts
z Bundled Windows utility and quick programming library for VB, VC++, BCB
z Supports RS-485 modules for expandable I/O
z Supports SCADA software such as Wonderware InTouch and GE Intellution iFix32
z SNMP for system management and I/O status
z Remote management over the network including firmware updates
z Supports use of TFTP server to import configuration
z Configurable DO power-on and safe status settings
z Optional hot-pluggable LCM for status display and configuration
Packing List
The ioLogik E2210 is shipped with the following items:
Standard Accessories
z ioLogik E2210 Active Ethernet I/O Server
z Software CD
Optional Accessories
z LDP1602 ioLogik Liquid Crystal Display Module (LCM)
NOTE: Notify your sales representative if any of the above items are missing or damaged.
Product Specifications
LAN
Ethernet 10/100 Mbps, RJ45
Protection 1.5 KV magnetic isolation
Protocols Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP(MIB for I/O an
Network), HTTP
Serial
Interface RS-485 (2-wire): Data+, Data-, GND
Serial line protection 15 KV ESD for all signals
To Next Page
Loading...
