ioLogik E2210 User’s Manual Using the Web Console
4-8
Change Password
For all changes to the ioLogik E2210’s password protection settings, you will first need to enter the old
password. Leave this blank if you are setting up password protection for the first time. To set up a new
password or change the existing password, enter your desired password under both New password and
Confirm password. To remove password protection, leave the New password and Confirm password
fields blank.
ATTENTION
If you forget the password, the ONLY way to configure the ioLogik E2210 is by using the reset button
to load the factory defaults.
Before you set a password for the first time, it is a good idea to export the configuration to a file when
you have finished setting up your ioLogik E2210. Your configuration can then be easily imported back
into the ioLogik E2210 if you need to reset the ioLogik E2210 due to a forgotten password or for other
reasons.
Load Factory Default
This function will reset all of the ioLogik E2210’s settings to the factory default values. All previous
settings including the console password will be lost.
Save/Restart
If you change the configuration, do not forget to reboot the system.
To Next Page
Loading...
Need help?
General
