ioLogik E2210 User’s Manual Using ioAdmin
3-10
Server Settings Tab (Administrator)
You may set up a password, server name, location, date, time zone, and time server in the Server Settings
tab.
Network Tab
The Network tab is where you configure IP settings, Modbus/TCP Alive Check Timeout settings, DNS
settings, Serial settings, SNMP settings, and Web Access settings for the ioLogik E2210.
IP Settings: You can set up a static or dynamic IP address for the ioLogik E2210, as well as the subnet
mask and gateway address. The Accessible IP screen can be used to control network access to the
ioLogik E2210 and attached sensors. Network requests that originate from sources that are not listed in
the accessible IP list will be unable to use Modbus/TCP or ioAdmin to access the ioLogik E2210.
Modbus/TCP Alive Check Timeout Settings: The Modbus/TCP Alive Check Timeout is designed to
avoid TCP connection failure. When the host is down, the ioLogik 2210 will continue to wait for a