E
E
Appendix E. Factory Default Settings
The ioLogik E2210 is configured with the following factory defaults:
Default IP address: 192.168.127.254
Default Netmask: 255.255.255.0
Default Gateway: 0.0.0.0
Communication watchdog: Disable
Modbus TCP alive check Timeout: 60 secs
DI Mode: DI
Filter time: 100 × 0.5 ms
Trigger for counter: Lo to Hi
Counter status: Stop
DO Mode: DO
DO Safe Status: Off
Power on status: Off
Low width for pulse: 1 × 0.5 ms
Hi width for pulse: 1 × 0.5 ms
Output pulses: 0 (continuous)
Password: NONE
Module Name: NONE
Module Location: NONE
SNMP: Enable
Community: Public
Contact: NONE
Location: NONE
Click&Go NONE
To Next Page