OnCell G3100 Series Using the Web Console
After adding the OnCell G3100’s IP address as a trusted site, you should be able to view the web console by
entering the OnCell G3100’s IP address in your browser’s address bar.
Opening the Web Console
Open your web browser and enter 192.168.127.254 in the website address line. This is the default IP address
for the OnCell G3100—if a new address has been assigned, enter the new address instead. Press ENTER to load
the page.
ATTENTION
The examples and figures
in this chapter use the OnCell G3100 factory default IP address of
If you have assigned a different IP address to your OnCell G3100, be sure to adjust
accordingly when following these directions.
Please refer to Chapter 3, Initial IP Address Configuration, for
how to configure the IP address.
Enter the console password if prompted. (This will not apply if you did not enable password protection for your
OnCell G3100.) The password will be transmitted with MD5 encryption over the Internet.
ATTENTION
If you forget your password, the ONLY way to configure the
OnCell G3100
is by using the reset button to reset
all settings and load the factory defaults
. If you have disabled the reset button in your OnCell G3100
configuration, you may still use it to load the factory defaults within the first 60 seconds that the OnCell G3100
is powered on.
up your configuration by exporting it to a file. Your configuration can
be easily restored by
importing the file to the
OnCell G3100. This will save time if you have forgotten the password and need to
reload the factory defaults.
To Next Page
Loading...
Need help?
General
