OnCell G3100 Series Software Installation/Configuration
3. Extract the source files from the tar file by executing the command:
# tar xvf moxa_oncell_fixedtty.tar
The following files will be extracted:
README.TXT
oncellttyd.c --- source code
oncellttyd.cf --- an empty configuration file
Makefile --- makefile
VERSION.TXT --- fixed tty driver version
FAQ.TXT
4. Compile and Link
For SCO UNIX:
# make sco
For UnixWare 7:
# make svr5
For UnixWare 2.1.x, SVR4.2:
# make svr42
Configuring the UNIX Driver
Modify the configuration:
The configuration used by the oncellttyd program is defined in the text file oncellttyd.cf, which is in the
same directory that contains the program oncellttyd. You may use vi, or any text editor to modify the file, as
follows:
ttyp1 192.168.1.1 950
For more configuration information, view the file oncellttyd.cf, which contains detailed descriptions of the
various configuration parameters.
The “Device Name” depends on the OS. See the Device Naming Rule section in README.TXT for more
information.
To start the oncellttyd daemon after system bootup, add an entry into /etc/inittab, with the tty name you
configured in oncellttyd.cf, as in the following example:
ts:2:respawn:/usr/etc/oncell_fixedtty/oncellttyd –t 1
Device naming rule
For UnixWare 7, UnixWare 2.1.x, and SVR4.2, use:
pts/[n]
For all other UNIX operating systems, use:
ttyp[n]
Starting moxattyd
Execute the command init q or reboot your UNIX operating system.
To Next Page
Loading...
Need help?
General
