OnCell G3100 Series Software Installation/Configuration
4. To change the configuration of the IP Address Report, click on the Settings icon to open the IP Location
Settings. The Local UDP listen Port number should match the web console Auto IP Report Settings’ port
number.
5. Click the Go icon to complete the configuration. Please refer to Chapter 6, Using the Web Console, for
information on how to use the IP Address Report.
Moxa OnCell Linux Real TTY Driver
Basic Procedure
To map an OnCell G3100 serial port to a Linux host’s tty port, follow these instructions:
1. Set up the OnCell G3100. After verifying that the IP configuration works and you can access the OnCell
G3100 (by using ping, telnet, etc.), configure the desired serial port on the OnCell G3100 to Real COM
mode.
2. Install the Linux Real TTY driver files on the host.
3. Map the OnCell serial port to the host’s tty port.
To Next Page
Loading...
Need help?
General
