OnCell G3100 Series System Management Settings
Load Factory Defaults
This function will reset all of OnCell G3100’s settings to the factory default values. All previous settings
including the console password will be lost. If you wish to keep the OnCell G3100 IP address, netmask, and
other IP settings, make sure Keep IP settings is checked off before loading the factory defaults.
Change Password
For all changes to the OnCell G3100’s password protection settings, you will first need to enter the old password.
Leave this blank if you are setting up password protection for the first time. To set up a new password or change
the existing password, enter your desired password under both New password and Confirm password. To
remove password protection, leave the New password and Confirm password boxes blank.
ATTENTION
If you forget the password, the ONLY way to configure the
OnCell G3100 is by using the r
eset button on the
OnCell G3100’
s casing to load the factory defaults.
Before you set a password for the first time, it is a good idea
to export the configuratio
n to a file when you
have finished setting up your
OnCell G3100. Your configuration can then be easily imported back into the
if you need to reset the OnCell G3100 due to a forgotten password or for other reasons.
efer to the section on Configuration Import/Export earlier in this chapter for more details.
To Next Page
Loading...
Need help?
General
