OnCell G3100 Series Using the Web Console
Gratuitous ARP: In some applications, you may need the OnCell G3100 to send broadcast packets to update
the ARP table on the server. If you enable this function and set the send period, the OnCell G3100 will
periodically send broadcast packets at the specified time interval.
Auto IP Report Settings
Access Auto IP Report Settings by expanding the Network Settings item in the navigation panel.
When the OnCell G3100 products are used in a dynamic IP environment, users must spend more time with IP
management tasks. For example, if the OnCell works as a server (TCP or UDP), then the host, which acts as a
client, must know the IP address of the server. If the DHCP server assigns a new IP address to OnCell, the host
must have some way of determining OnCell’s new IP address.
OnCell G3100 products help out by periodically reporting their IP address to the IP location server, in case the
dynamic IP has changed. The parameters shown below are used to configure the Auto IP report function. There
are two ways to develop an “Auto IP report Server” to receive the OnCell’s Auto IP report.
Use the OnCell Search Utility’s IP Address Report function. Please refer to OnCell Search Utility Configuration
in Chapter 15.
“Auto IP report protocol,” which can automatically receive the Auto IP report on a regular basis, is also available
to help you develop your own software. Refer to Appendix E for the “Auto IP report protocol.”
Auto IP report to host: Reports generated by the Auto report function will be sent automatically to this IP
address or host name.
Report to UDP port (default=63100): This is the UDP port number assignment for the serial port on the
OnCell G3100.
Report period (default=99): You can use this option to set how often the IP address is automatically
reported.
the
OnCell Search Utility to receive the auto IP report message sent from the OnCell G3100, please
also install Windows Driver Manager. Windows Driver Manger help
s dispatch messages
to the OnCell Search
Utility.
To Next Page
Loading...
Need help?
General
