OnCell G3100 Series System Management Settings
Remote Management
Remote SMS Control
Remote SMS Control can be used when your OnCell devices are installed in locations that are not easy to
access and where GPRS service is unstable. SMS service is one of the most reliable cellular services. Remote
SMS control provides: 1) the ability to report the current status of the OnCell device to your SMS sender; 2) the
ability to reboot the device so it can be recovered from any unexpected situation.
Remote SMS Control: Enable or disable the ability of the OnCell to be controlled by SMS (default: disabled).
Password: Set your password (4-16 characters).
Auth type: You can restrict the access by enabling the Caller ID under Auth Type.
Caller ID: Enter Caller ID number so that only SMS from specific senders can trigger Remote SMS control.
restart: When receiving the SMS message [@password@restart], the device will reboot. Ex. If
Password=12345, then sending an SMS notification that reads @12345@restart to the OnCell will reboot the
OnCell.
cell. report: When receiving the SMS message [@password@cell.report], the device will reply with the current
cellular status.
Action: Execute an operation upon receiving an SMS notification.
Acknowledge: Reply to the SMS sender with an SMS message after the operation is completed.
Example: If Password=12345, then sending an SMS notification that reads @12345@cell.report to the
OnCell will cause the OnCell device to send an SMS response detailing its cellular status.
To Next Page
Loading...
