OnCell G3100 Series Software Installation/Configuration
Overview
To ensure that installation and configuration are easy and straightforward, download the following software
and utilities from www.moxa.com
: Windows Driver Manager (for COM mapping), OnCell Search Utility (to
broadcast search for all OnCell G3100’s accessible over the network), the OnCell G3100 User’s Manual, and the
OnCell firmware upgrade utility.
Windows Driver Manager
Installing Windows Driver Manager
OnCell Windows Driver Manager is intended for use with OnCell G3100 serial ports that are set to Real COM
mode. The software manages the installation of drivers that allow you to map unused COM ports on your PC to
serial ports on the OnCell G3100. These drivers are designed for use with Windows
98/ME/NT/2000/XP/2003/Vista/2008/7/8/10. When the drivers are installed and configured, devices that are
attached to serial ports on the OnCell G3100 will be treated as if they were attached to your PC’s own COM
ports.
1. Download Windows Driver Manager from www.moxa.com
, and then click the INSTALL COM Driver button
to install the Windows Driver. Once the installation program starts running, click Yes to proceed.
2. Click Next when the Welcome screen opens, to proceed with the installation.
To Next Page
Loading...
Need help?
General
